Product features
Thermoplastic enclosure
4 x Socket M8
sWave® wireless technology
No wiring and cable laying required
Power supply by Lithium battery
Output signal can be individually configured at the receiver
LBT - Listen before Talk Firmware
With SMA connector for external antenna to increase range
Notes
The RF I/O BU may be used in combination with wireless inductive sensor RF IS M… FL.
The battery is included in delivery.
Technical data
General technical data
Applied standards
EN IEC 60947-5-1, EN 301 489-3, EN IEC 61000-6-2, EN IEC 61000-6-3, EN IEC 63000
Enclosure
ABS, UL 94 HB, RAL 9005
Antenna
internal antenna
Tightening torque
enclosure mounting screws: max. 1.5 Nm
cover screws: max. 1.5 Nm
Degree of protection
IP65 (IEC/EN 60529), only with plugged cables and/or with closed protective caps
Safety class
III
Ambient temperature
–20 °C … +80 °C
Type of installation
mount on an even surface
Mounting position
any
Mounting
screw connection
Connection
4 x socket M8 x 1, 4-pole
Switching thresholds
max. switch-on threshold: 2.05 V,
min. switch-off threshold: 0.95 V
Switch-on delay ton
max. 0.94 ms
Switch-off delay toff
max. 94.7 ms
Actuating time
min. 80 ms
Telegram rate
max. 12000 telegrams with repetitions/h
Switching frequency
max. 5 Hz
Standby current
60 µA
Note
status signal – can be individually configured via radio receiver (delivery state: without status signal)
LBT – can be deactivated via radio receiver (e.g. in conjunction with repeaters)
transmission of battery voltage and switching condition
Go to our different wireless receivers to find corresponding how-to videos.
Wireless approvals
Europe: RED 2014/53/EU
Wireless technology
Frequency
868.3 MHz (Europe)
Data rate
66 kbps
Channel bandwidth
350 kHz
Modulation type
2-FSK
Protocol
sWave®
Transmission power
< 25 mW
Wireless range
max. 450 m outdoors, max. 40 m indoors
Voltage supply
Voltage source
lithium battery Tadiran SL-760 (AA), replaceable
System
Li/SOCl2
Nominal voltage
3.6 V
Nominal capacity
2.2 Ah
Battery life
depending on operation cycles and number and type of sensors for 1,000 transfers/day and one inductive sensor FL approx. 1,900 days; for 1,000 transfers/day and one mechanical switch about 10 years
Inductive sensor FL 1 x
10 s: approx. 3.9 years; 100 s: approx. 5.1 years; 1,000 s: approx. 5.1 years
Inductive sensor FL 4 x
10 s: approx. 1.7 years; 100 s: approx. 1.9 years; 1,000 s: approx. 1.9 years
Battery life – external contact / magnetic sensor 1 x
mainly activated
10 s: approx. 6.9 years; 100 s: >10 years
mainly inactivated
10 s: approx. 7.9 years; 100 s: >10 years
Battery life – external contact / magnetic sensor 4 x
mainly activated
10 s: approx. 5.2 years; 100 s: approx. 7.4 years; 1,000 s: >10 years
mainly inactivated
10 s: ca. 7,9 years: 100 s: >10 years
Dimensional drawing
Further drawings
NC = not connected
