Wireless receiver
RF Rx - 4W
sWave® wireless technology
4 potential-free relay outputs
4 change-over contacts
Transmitter/receiver assignment by teaching mode
LEDs for indication of switching state
Notes
External antenna always required for optimum range and to meet the licensing requirements for radio communications.
Loading...
Found 2 results
Product
Standard Version
Product
Loaded 2 from 2 results
Technical data
General technical data
- Applied standards
- EN 300 220-2, EN 301 489-3, EN 60947-5-1, EN IEC 61000-6-2
- Enclosure
- polycarbonate, RAL 7035
- Degree of protection
- IP20 (IEC/EN 60529)
- Mounting
- DIN rail mounting
- Connection
- terminals with CAGE CLAMP WAGO Series 236: 0.08 … 2.5 mm² / AWG 28-12, AWG 12: THHN, THWN, stripping length 5 … 6 mm / 0.22 in
- Outputs
- 4 change-over contacts (relays)
- Rated operating current/voltage Ie/Ue
- max. 0.09 A/24 VDC -15 % … +10 %; max. 0.15 A/24 VAC -15 % … +10 %;
output contacts: 6 A/250 VAC; 2 A/24 VDC
- Utilisation category
- outputs: AC-15 (at 10 % Ie); DC-13
- Wireless range
- max. 450 m outdoors, max. 40 m indoors
- Rated insulation voltage Ui
- 250 VAC
- Rated impulse withstand voltage Uimp
- 2.5 kV
- Display
- 1 x green LED: ready for operation,
4 x orange LED: signalling of switching state
- Recovery time
- max. 24 ms (measured from the start of a radio telegram to the end of the relay contact bounce time, with 1 x repetition of the radio telegram due to transmission disturbance)
- Teachable transmitters
- 40
- Telegram rate
- max. 12000 telegrams with repetitions/h
- Degree of pollution
- 2
- Ambient temperature
- 0 °C … +55 °C
- Storage and shipping temperature
- –25 °C … +85 °C
- Note
- Inductive loads (contactors, relays etc.) are to be suppressed by suitable circuitry.
Allows configuration of LBT and status signal of the transmitters
- Wireless approvals
- Europe: RED 2014/53/EU
USA: FCC - VPYLBAA0QB1SJ
Canada: IC - 772C-LBAA0QB1SJ
Brazil: on request
Japan: on request
