ZS 92 S 02 VD Si-Bus B -40°C ... +70°C IP66/67 Extreme

Applied standards

EN 60947-5-1, EN 60947-5-5, EN ISO 13850, EN ISO 13849-1, EN 60529, EN 620-5.7.2.9, AS 1755-2000-2.7.9.1, AS/NZS 4024.3610:2015-2.10.6.2

Enclosure

aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, anthracite grey, similar to RAL 7016

Cover

aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, signal yellow, similar to RAL 1003

Actuating lever

aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, signal red, similar to RAL 3001

Reset lever

aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, sky blue, similar to RAL 5015

Screws

stainless steel

Tightening torque

cover screws: max. 2.5 Nm
actuator screws: max. 6 Nm

Degree of protection

IP66/IP67 (IEC/EN 60529)

B_10d (10 % load)

100 000

T_M

max. 20 years

Switching system

snap action, positive break NC contacts A

Switching elements

2 NC contacts, type Zb

Connection

screw connection terminals, basic strip to connect Dupline Safe input module with plug-in connector (see accessories)

Cable cross-section

0.5 ... 2.5 mm² (incl. conductor ferrules)

Cable entry

2 x M25 x 1.5

Rated impulse withstand voltage U_imp

4 kV

Rated insulation voltage U_i

250 V

Conventional thermal current I_the

6 A

Conditional short-circuit current

1100 A

Rated operating current/voltage I_e/U_e

6 A/250 VAC

Utilisation category

AC-15

Short-circuit protection

6 A gG fuse

Mechanical life

> 50 000 operations

Max. wire length

2 x 100 m

Note

At 3 m distance intermediate wire supports are required. Two compensation springs type ZS 92 S must be installed, see accessories.

Ambient temperature

with Si-Bus –40 °C … +70 °C;
without Si-Bus –40 °C … +85 °C

Degree of pollution

3

Actuating force

actuating lever approx. 30 N; reset lever approx. 40 N

Approvals

ßda