Emergency pull-wire switch
ZS 92 S 02 VD Si-Bus B -40°C ... +70°C IP66/67 Extreme
Article no.: 1363023
Product features
Suitable for installation of a safety bus module
With integrated 8-pole Phoenix multi-way connector and bracket for safety bus module
Temperature resistant from -40 °C to +70 °C
High degree of protection IP66 / IP67
Corrosion-resistant aluminium enclosure
Wire length up to 2 x 100 m
Release by lever
B = Reset lever on back
Rear and base mounting possible
Wire pull and breakage detection
Notes
The safety bus module is not included in delivery.
Technical data
General technical data
- Applied standards
- EN 60947-5-1, EN 60947-5-5, EN ISO 13850, EN ISO 13849-1, EN 60529, EN 620-5.7.2.9, AS 1755-2000-2.7.9.1, AS/NZS 4024.3610:2015-2.10.6.2
- Enclosure
- aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, anthracite grey, similar to RAL 7016
- Cover
- aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, signal yellow, similar to RAL 1003
- Actuating lever
- aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, signal red, similar to RAL 3001
- Reset lever
- aluminium die-cast, corrosion-resistant, powder-coated, passivated, shockproof, sky blue, similar to RAL 5015
- Screws
- stainless steel
- Tightening torque
- cover screws: max. 2.5 Nm
actuator screws: max. 6 Nm
- Degree of protection
- IP66/IP67 (IEC/EN 60529)
- B10d (10 % load)
- 100 000
- TM
- max. 20 years
- Switching system
- snap action, positive break NC contacts A
- Switching elements
- 2 NC contacts, type Zb
- Connection
- screw connection terminals, basic strip to connect Dupline Safe input module with plug-in connector (see accessories)
- Cable cross-section
- 0.5 ... 2.5 mm² (incl. conductor ferrules)
- Cable entry
- 2 x M25 x 1.5
- Rated impulse withstand voltage Uimp
- 4 kV
- Rated insulation voltage Ui
- 250 V
- Conventional thermal current Ithe
- 6 A
- Conditional short-circuit current
- 1100 A
- Rated operating current/voltage Ie/Ue
- 6 A/250 VAC
- Utilisation category
- AC-15
- Short-circuit protection
- 6 A gG fuse
- Mechanical life
- > 50 000 operations
- Max. wire length
- 2 x 100 m
- Note
- At 3 m distance intermediate wire supports are required. Two compensation springs type ZS 92 S must be installed, see accessories.
- Ambient temperature
- with Si-Bus –40 °C … +70 °C;
without Si-Bus –40 °C … +85 °C
- Degree of pollution
- 3
- Actuating force
- actuating lever approx. 30 N; reset lever approx. 40 N
- Approvals
- ßda
Dimensional drawing
Further drawings
Contact diagram
S1 - Switch insert 1
Switching diagram
U Latching point
V Wire breakage detection
W Wire pull detection
S1 - Switch insert 1
Installation of Si-Bus
Downloads
Loading...
Other interesting products
Emergency pull-wire switch
ZS 92 S 02 VD Si-Bus B -40°C ... +70°C IP66/67 ExtremeArticle no.: 1363023
