Product features
Stainless steel enclosure
sWave® wireless technology
Power supply by Lithium battery
No wiring and pipe laying required
Easy programming of receiver
Output signal can be individually configured at the receiver
LBT - Listen before Talk software (necessary in conjunction with potential interference)
Notes
2 mounting nuts are included in delivery
The actuator is not included in the delivery of the switches
Technical data
General technical data
Applied standards
EN 60947-5-1, EN IEC 61000-6-2, EN IEC 61000-6-3, EN 301 489-1, EN 301 489-3, EN 300 220-2
Enclosure
stainless steel 1.4539
Tightening torque
mounting nut: max. 75 Nm
Degree of protection
IP67 (IEC/EN 60529)
Type of installation
flush, in not ferromagnetic material
Ambient temperature
–20 °C … +65 °C
Switching system
reed contact
Rated switching distance sn
M 100: 15 mm; M 30 Niro: 30 mm
Hysteresis
< 1 mm
Operation cycles
max. 12000 telegrams with repetitions/h
Switching frequency
max. 5 Hz
Standby current
< 2 µA (< 5 µA activated)
Mechanical life
> 1 million operations
Actuating time
min. 80 ms
Note
status signal 10 s
transmission of battery voltage and switching condition
Wireless approvals
Europe: RED 2014/53/EU
Wireless technology
Protocol
sWave®
Frequency
868.3 MHz (Europe)
Transmission power
< 25 mW
Data rate
66 kbps
Channel bandwidth
480 kHz
Wireless range
max. 450 m outdoors, max. 40 m indoors
Voltage supply
Voltage source
lithium battery CR 2032 (replaceable)
System
Lithium-MnO2
Nominal voltage
3 V
Nominal capacity
0.23 Ah
Battery life
depending on operation cycles (typ. @ 20 °C)
10 s: 1.1 years; 100 s: 5.0 years; 1000 s: 7.6 years; without: 8.0 years
Downloads
Variants / Options
The following variants / options are available on request:
LBT - Listen before Talk software (necessary in conjunction with potential interference)
Sensor based on GMR effect (RF GS M30 …)
Other interesting products
